Panzer4 Turret Roof Armor Thickness

The front glacis was 25 mm thick.

Panzer4 turret roof armor thickness.

The armor on the front sides and rear of the turret was 30 mm thick. 50 mm anti radiation liner 40 mm thick roof armor 80 mm polyurethane 2 mm steel 7 mm explosive 2 mm steel 10 mm high hardness steel or 191 mm of armor of which 90 mm are part of the turret roof and 101 mm applique armor. Armor on the lower hull front. Panzer ivs up through the f1 model used short 75l24 guns and had a maximum frontal armor thickness of 50mm on both the turret front and the front hull.

30 mm armour was used on the hull sides lower hull rear and front. The new factory full size rotor shield covered the majority of the turret face with much thicker armor. J were produced without face hardened armor and the superstructure roof was thickened to 16 mm. The turret s armor protection was considered insufficient.

Note some descriptions of panzer iv armor layouts distinguish the front hull the superstructure and the turret. D were produced with 50 mm. Depending on the source the front armor thickness of the turret varies between 15 to 20 mm. The last 68 ausf.

The rounded gun mantle was 50 mm thick. The basic armor thickness at the hull front upper hull front and rear of the tank was now 50 mm. The british matilda ii was also heavily armored with at least 70 mm 2 76 in of steel on the front and turret and a minimum of 65 mm on the sides 79 but were few in number. Preference given to data from jentz.

The turret lacked an internal rangefinder. The commander s cupola had all around 14 5 mm of armor with the two hatch doors being 8 mm thick. G were produced without the added 30 mm. The design has a narrower turret front and an external rangefinder located in a bulge on the turret.

The front turret armor was 16 mm at a 10 angle while the sides and rear were 14 5 mm at 25 angle and the top was 10 mm at 83 90 angle. The somua s35 had a maximum armor thickness of 55 mm 2 2 in while the kwk 37 l 24 could only penetrate 43 mm 1 7 in at a range of 700 m 2 300 ft. Based on a scale drawing probably taken from the t 72 manual the turret armor was estimated to be 475 mm thick at the turret cheeks. Armor thickness is rounded to the nearest integer with halves rounding up for odd integers and down for even ones.

It is based on the total size of the turret the empire s best researched armor type and the armor thickness. So the whole array would be. According to declassified documents from the cia a measurement of the t 72 turret at the port of the coaxial machine gun revealed an armor thickness of 350 milimetres. The rounded gun mantlet deflected shots into the thin hull roof.